Characterization of variables related to high stability of raw cow milk.

This research paper analyzes the stability of raw cow milk in the alcohol test and seeks to understand to know the factors that influence milk stability and the occurrence of unstable non-acid milk. Milk samples were collected from the cooling tanks of rural farmers in the state of Paraná twice in summer and twice in winter. The farms were classified according to the production system: pasture with supplementation and feedlot. The following variables were analyzed: stability in the alcohol test, titratable acidity, ionized calcium concentration (iCa), chemical composition of milk, somatic cell count and standard plate count. The results showed that milk stability was greater in winter vs. summer, when the milk contained higher iCa, and in the feedlot vs. pasture system. The Pearson Correlation between variables (ethanol stability, milk composition, iCa, cooling tank temperature, milk volume, number of milking, number of cows milked, fat/protein ratio, distance and travel time) were analyzed. Stability was negatively correlated with iCa concentration and positively with lactose content. Logistic regression of the risk of unstable non-acid milk at 72% alcohol (UNAM72) showed that only iCa and lactose were determinants, while evaluation of the same risk at 78% alcohol revealed iCa, titratable acidity, lactose and milk urea nitrogen as risk factors. Under the dairy farming conditions of Paraná state, the frequency of UNAM72 was low (12.16%) and was higher in summer and in pasture systems with supplementation. In conclusion, in dairy herds bred with high technological level, with adequate nutritional and health management, the frequency of UNAM is low and is related to nutritional management abnd, perhaps, heat stress, factors that alter iCa and lactose levels.

Assessment of physicochemical, textural and microbiological properties of brazilian white mold surface-ripened cheeses: a technological approach / Avaliação das propriedades físico-químicas, de textura e microbiológicas de queijos brasileiros maturados com mofo branco: uma abordagem tecnológica

ABSTRACT: There are no specific technical regulations regarding the identity and quality of white mold surface-ripened cheeses in Brazil. These cheeses are sold both whole (Camembert-type) and in wedges (Brie-type). The aim of the study was to evaluate the physical and chemical properties; technological parameters and microbiological safety of 20 whole cheeses (Camembert-type) and 16 cheese wedges (Brie-type) produced in Brazil. Samples showed a wide range in sodium (91.0-731.0 mg/100 g, cheeses wedges) and calcium (238.0-1100.0 mg/100g, whole cheeses) contents. The cheese groups presented no significant differences in relation to the majority of the analyzed parameters. Listeria monocytogenes was reported in 5% of the whole cheese samples. The other microbiological parameters were in accordance with the current legislation, RDC no 12/2001 of Anvisa. The comparative assessments between these two cheeses indicated that they are different. In addition, the wide range of results indicated a lack of processing standardization. The mean values of the physicochemical and textural parameters should be considered as recommended for these cheeses in Brazil.

RESUMO: No Brasil, não há uma regulamentação técnica específica sobre a identidade e qualidade de queijos maturados com mofo branco na superfície. Estes queijos são comercializados inteiros (tipo Camembert) e em cunhas (tipo Brie). O objetivo da pesquisa foi avaliar as propriedades físicas e químicas; parâmetros tecnológicos e marcadores microbiológicos de 20 queijos inteiros (tipo Camembert) e 16 cunhas de queijo (tipo Brie) produzidos no Brasil. Os teores de sódio e cálcio apresentaram elevada amplitude (8,0 e 4,6 vezes o valor mínimo, respectivamente). Os valores médios destes queijos não apresentaram diferenças significativas em relação à maioria dos parâmetros analisados. Listeria monocytogenes foi encontrada em 5% das amostras de queijo tipo Camembert. Os demais parâmetros microbiológicos estavam de acordo com a legislação vigente, RDC no 12/2001 da Anvisa. Esta avaliação comparativa entre estes dois queijos indica que são diferentes. Além disso, os valores com elevada amplitude correspondem a falta de padronização do processamento. Os valores médios poderiam ser considerados como recomendados para estes queijos no Brasil.

Organic amaranth starch: A study of its technological properties after heat-moisture treatment.

Organic amaranth starch (Amaranthus caudatus) was studied after heat-moisture treatment (HMT) using different moisture contents and different times. The starch extracted by the aqueous method presented low lipid and protein content. After HMT, an increase in the thermal stability was identified. The onset and peak temperatures were higher with an increase in moisture content and the times used in the modification. The gelatinisation enthalpy varied due to the heterogeneity of the crystals formed after the structural reorganisation caused by HMT. The relative crystallinity was lower for the physically modified starches. An increase in the pasting temperature was accompanied by a decrease in the viscosity, setback and breakdown, which were proportional to the moisture and time used. The morphology of the HMT-modified samples was not altered; however, agglomerations were noted. Low levels of dispersion homogeneity and suspension stability were observed for the modified samples due to the strong presence of agglomerates.

Ripened Semihard Cheese Covered with Lard and Dehydrated Rosemary (Rosmarinus officinalis L.) Leaves: Processing, Characterization, and Quality Traits.

This study aimed to establish a manufacturing protocol and to characterize semihard cheese covered with lard and rosemary during ripening. After the manufacturing protocol was defined, the cheeses were produced with pasteurized and raw milk from Holstein cows, with and without (control) coating, and then ripened for 60 d. During this period the physicochemical properties, color, proteolysis, texture profile, and sensory acceptance were performed. The early-ripening cheeses differed from the others in terms of color and moisture content. Multivariate statistical analysis separated chesses in groups differentiated by the effects of heat treatment of milk and ripening period. The ripened cheeses obtained from raw milk were sensorially more preferred. The coating gave the final products higher moisture content and favored color and texture characteristics. Consumer testing showed that the cheese obtained from raw milk and coated with lard and rosemary was the most preferred (acceptance of 82%) due to the specific coating of rosemary (aroma and flavor). This product has potential to add value and to diversify the production of semihard cheeses.